PSU 5V for Scaler or Sync Strike
- 5V regulated PSU for use with scaler or Sync Strike.
Specify if you need a
plug (scaler, SLG SCART, UMSA) or
open wires (Sync Strike)
You need for the DIY scaler kit only 1 PSU.
Installation of PSU for Sync Strike
Situation : You`ve two wires, one is GND and one is 5V coming from a PCB.
Step 0. Relax, take a seat and your favourite beverage with you. Check your tools and documentation. Disconnet the PCB and the PSU!
Step 1. Strip the isolation of both wires, about 10mm wiht the pliers.
Expected result : blank wires on both wire ends.
Step 2. Take the 5V wire and put it to the 5V screw terminal. Fix the wire in the scew terminal with the screw driver.
Expected Result : 5V wire of the PCB is fixed via screw terminal to the 5V part of the PSU.
Step 3. Take the GND wire and put it to the GND screw terminal. Fix the wire in the scew terminal with the screw driver.
Expected Result : GND wire of the PCB is fixed via screw terminal to the GND part of the PSU.
Step 4. Connect the PSU to the wall socket.
30 cm langes Kabel zur Stromversorgung von Supergun MAK Strike.
Diesen Artikel haben wir am 01.04.2021 in unseren Katalog aufgenommen.